Removing Expansion-Card Risers - Dell PowerVault NX3300 Owner's Manual

NOTE: When installing a GPU card on riser 3, connect the GPU card power cable to the power connector on riser 3.
10. Close the system.
11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
12. Install any device drivers required for the card as described in the documentation for the card.

Removing Expansion-Card Risers

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: The expansion-card riser 1 and the x16 link on the riser 2 slot can be used only when both the processors
are installed.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2. Open the system.
3. Holding the touch points, lift the expansion-card riser from the riser connector on the system board.
Figure 21. Removing and Installing the Expansion Card Riser 1
1. expansion-card riser 1
2. expansion card
3. riser guide back (right)
4. riser guide back (left)
55