Channel Details; Alerts; Client Alerts - Dell PowerConnect W-IAP3WN User Manual

Channel Details

When you move your mouse over a channel, the channel details or the summary of the 5 GHz and
2.4 GHz channels as detected by a spectrum monitor are displayed. You can view the aggregate
data for each channel seen by the spectrum monitor radio, including the maximum AP power,
interference and the Signal-to-Noise and Interference Ratio (SNIR). Spectrum monitors display
spectrum analysis data seen on all channels in the selected band, and hybrid W-IAPs display data
from the one channel they are monitoring.
- Channel Details Information
Figure 21
For more information on spectrum monitoring, see

Alerts

Alerts are generated when a user faces problems while accessing or connecting to the Wi-Fi
network. The Alerts link appears in red if there are any Client Alerts, or Active Faults.
- Alerts Link
Figure 22

Client Alerts

These alerts occur when clients are connected to the W-Instant network. A client alert consists of
the following fields:
Timestamp— Displays the time at which the client alert was recorded.
l
MAC address— Displays the MAC address of the client which caused the alert.
l
Description— Provides a short description of the alert.
l
Access Points— Displays the IP address of the W-IAP to which the client is connected.
l
Details— Provides complete details of the alert.
l
Dell PowerConnect W-Series Instant Access Point
"Spectrum Monitor" on page
6.2.0.0-3.2.0.0 | User Guide
97.
37 | Dell W-Instant User Interface