Sharp VC-A565U Operation Manual page 32

D A T E C H
8 / 1 0 0 7
- - / - - - - -
- - / - - - - -
- - / - - - - -
T U R N V C R P O W E R O F F
F O R T I M E R R E C O R D I N G .
• If the power is interrupted for more than 5 seconds (power failure, etc.) during timer recording, the Auto Clock Setting will
reset the time after the power is returned (the timer indicator on the multi-function display will flash.) but the timer settings will
be cancelled.
• Numbered buttons can be used instead of ∂/ƒ to set the data.
• If the cassette ends before recording all the programmes, the VCR will stop, turns its power off and ejects the tape
automatically.
• In Step (, if POWER is pressed with no cassette inserted, the TIMER indicator flashes for 5 seconds indicating that timer
recording is not possible.
• In Step (, if the inserted cassette is without the erasure protection tab, TIMER indicator flashes and the cassette is ejected.
• To stop timer recording, press STOP.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
• There are two timer setting screens (1/2, 2/2).
32
& Press SET.
1 / 2
S T A R T S T O P
9 : 0 5 PM 1 0 : 3 5 PM S P
- : - - - : - - - -
- : - - - : - - - -
- : - - - : - - - -
* Press MENU to finish settings.
Normal
Screen
( Press POWER to enter the timer standby mode. Be sure
• To programme the additional timer settings, press SET
and repeat steps @–&.
The display shown to the left appears on the screen for 5
seconds, after which the normal screen returns.
that " " is lit up on the multi-function display.
Recording with the Timer