Table of Contents
Advertisement
Click the "Next" button.
13
Click the "Finish" button.
14
Restart your computer.
15
You have completed the installation of the AJ-6000 series driver.
After installing the AJ-6000 series driver, install AJ-6000 series software referring
to the next page.
Installing through "Setup" (Windows 95/98, parallel interface)
If the driver failed to be installed when connected by the parallel interface and following the
procedures outlined in "Installing onto Windows 98" (page 27), or "Installing onto Windows
95" (page 28), follow the steps shown below. The steps also help you reinstall the driver
when necessary.
Make sure that the unit is connected to your computer.
1
Turn on the unit, and then turn on your computer.
2
Insert the supplied CD-ROM into your CD-ROM drive.
3
Click the "Start" button, and select "Run".
4
Type "D:\DRIVERS\MFP-PS\NEUTRAL\SETUP\SETUP.EXE", and
5
then click the "OK" button.
(Change "D" to correspond to the letter of your CD-ROM drive.)
The setup program will start to copy the files.
If your operating system is Windows 98, restart your computer. With Windows 95,
go to step 6.
Check the radio button for "Yes", and click the "Finish" button.
6
You have completed the installation of the AJ-6000 series driver.
After installing the AJ-6000 series driver, install AJ-6000 series software referring
to the next page.
INSTALLING THE "AJ-6000 SERIES DRIVER"
31
Advertisement
Table of Contents
