Quick Guide; Attaching The Stand; Setting The Tv - Sharp Aquos LC-32GA9E Operation Manual

Quick guide

Attaching the stand

Before performing work spread cushioning over the base area to lay the TV on, making sure the
area is completely flat. This will prevent it from being damaged.
Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
1
Confirm the 8 screws supplied with the TV.
Short screws (m4)
(used in step 2)
3
Insert the stand into the opening on the bottom of
the TV.
NOTE
• To detach the stand, perform the steps in reverse order.

Setting the TV

Standard DIN45325
plug (IEC 169-2)
75-ohm coaxial cable
Cable tie
Setting the TV on the wall
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
Long screws (m4)
(used in step 4)
Ferrite Core
The Ferrite Core should be permanently attached
and never removed from the AC cord.
2
Attach the two parts of the stand unit to each other
using the 4 short screws as shown.
4
Insert and tighten the 4 long screws on the rear
of the TV as shown.
Ferrite Core
Place the TV close to the
AC outlet, and keep the
power plug within reach.
Product shape
varies in some
countries.
AC cord
Cable clamp
3