Removing The Stand And Speaker - Sharp Aquos LC-37GD1E Operation Manual

Preparation

Removing the stand and speaker

This unit has detachable type speaker.
You can detach the system speaker when using external speaker.
Before removing (or attaching) speaker, unplug the AC cord from the AC outlet and the system cable from the
Display.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
• When using the TV with the supplied stand attached, do not remove the speaker. Doing so may disturb
the balance leading to product damage or personal injury.
Before attaching/removing speaker
• Before performing work make sure to turn off the System.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
1
Unfasten the screws used to
secure the stand in place, and then
detach the stand from the Display.
(Hold the stand so it will not drop
the stand from the edge of the base
area.)
4
Unfasten the screw used to
secure the speaker bracket.
CAUTION
• The speaker terminals on the Display are only for the attached speaker. Do not connect any third party plug or speaker
to the terminal.
• Insert the speaker plug completely into the terminal.
NOTE
• To attach the speaker and stand, perform the above steps in reverse order.
2
1 Unfasten the screws used to
secure the speaker bracket
covers, and then detach them.
2 Take off the speaker terminal
cover.
5
Now the speaker can be removed
from the Display.
3
Disconnect the cable from the
speaker.
9