Removing The Stand And Speaker; Setting The Tv On The Wall - Sharp Aquos LC-32GA3E Operation Manual

Preparation

Removing the stand and speaker

This unit has detachable type speaker.
You can detach the system speaker when using external speaker.
Before removing (or attaching) speaker, unplug the AC cord from the AC outlet.
CAUTION
• Do not remove the stand and speaker from the TV unless using an optional bracket to mount it.
• When using the TV with the supplied stand attached, do not remove the speaker. Doing so may disturb
the balance leading to product damage or personal injury.
Before attaching/removing speaker
• Before performing work make sure to turn off the TV.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Unfasten the screws used to
secure the stand in place, and then
detach the stand from the Display.
(Hold the stand so it will not drop
the stand from the edge of the base
area.)
4
Unfasten the screw used to
secure the speaker bracket.
CAUTION
• The speaker terminals on the TV are only for the attached speaker. Do not connect any third party plug or speaker to the
terminal.
• Insert the speaker plug completely into the terminal.
NOTE
• To attach the speaker and stand, perform the above steps in reverse order.

Setting the TV on the wall

CAUTION
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the TV to the
wall.
2
1 Unfasten the screws used to
secure the speaker bracket
covers, and then detach them.
2 Take off the speaker terminal
cover.
5
Now the speaker can be removed
from the Display.
3
Disconnect the cable from the
speaker.
• Perform the steps 2 to 4 on the
both sides of the speaker to
remove it.
7