NEC Express5800/120Rg-2 User Manual page 295

7.
Check to see that the RMC is fixed with both levers on the RMC connector.
8.
<Advanced Remote Management card (ARMC) only>
a) Assemble the management network card that attached to the ARMC and install the card
to the riser card.
b) Connect the internal cable that attached to ARMC to ARMC and the management
network card as shown in the figure below.
The following figure shows the cable routing of the internal cable.
9.
Reassemble the server.
10.
Turn on the server and check that the no error messages other than the following message
are displayed on the POST screen.
H/W Configuration of BMC is corrupted.
!!Update BMC H/W Configuration by configuration tool!!
!!Refer to BMC configuration manual!!
See Chapter 8 for POST error messages.
Upgrading Your Server 9-55