1.
Mounting Procedure
Mounting Procedure
1. Insert the UG230 into the mounting panel (max. thick: 5 mm).
Panel cut-out hole
2. Insert four fixtures attached to the UG230 into the mounting holes, and tighten them with the
locking screws.
Tightening Torque: 0.3 to 0.5 N•m
Fixture dimensions
(Unit: mm)
17.8
* To prevent static electricity, be sure to
connect the mounting panel to the ground.
3. Mount the gasket so that it will be sandwiched securely between the unit and the mounting panel.
Mounting Angle
Install the unit within the angle of 0° to 135° as shown on the right.
Fixtures
Mounting hole
10.5
1. Mounting Procedure
Mounting panel
• Panel cut-out dimensions
(Unit: mm)
90
135
3-1
3
Mounting hole
UG230
Mounting
panel
Fixtures
0