This RF Modulator Kit includes everything you need to convert the separate audio and video
signals (from a video camera, computer, portable VCR, or satellite receiver, for example) into an
RF TV signal that you can view through the RF jack on your TV set.
In addition to the RF Modulator, this kit has the following
cables for connecting your component and your TV:
• 1 3FT. Audio/Video Cable
• 1 3FT. Coaxial Cable
These are all the cables you need for a basic connection.
Depending on the connections offered by your TV and your
input component, you might also want to use the following
• 1 S-Video Cable (not included)
• 1 75-ohm to 300-ohm matching transformer (not
You can seat the RF modulator either vertically or horizontally.
To seat the RF Modulator vertically :
Slide the seat plate (included)
onto the bottom of the RF
Modulator until the locking
tab of the seat plate clicks in
to secure the plate to the RF
Note: To remove the seat plate
once you've seated the RF
Modulator, pull up the locking
tab on the bottom of the plate
and push the seat plate off of
the RF Modulator.
RF Modulator Kit
with S-Video Input
DH93RF User's Manual
Consulte el reverso para instrucciones en español
The FCC Wants You to Know
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Your modulator might cause TV or radio interference even when is operating
properly. To determine whether your modulator is causing the interference,
turn it off. If the interference goes away, your modulator is causing it.
Try to eliminate the interference by:
• moving your RF Modulator away from the receiver
• connecting your RF Modulator to an outlet that is on a different
electrical circuit from the receiver
• contacting your local store for help
If you cannot eliminate the interference, the FCC requires that you stop
using your RF Modulator.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's FCC authorization to operate this equipment.
Note to the CATV System Installer: This reminder is provided to call
the CATV system installer's attention to article 820-22 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
To seat the RF Modulator horizontally :
Attach the four self-adhesive rubber pads (included) to
the side face of the RF Modulator.
Then, turn the RF Modulator onto the side with the