Texas Instruments TI-83 Plus Manual Book page 175

³ Try-It!é on Your TI.83 Plus or TI.73
Set Up the List Editor
Use the commands
To Do This
1. Display the list editor.
Note: Your list editor may vary. The following
commands will clear and set up lists L1 through L6
in your list editor.
2. Return to the Home screen and clear
it. Then clear all lists in the list editor
by selecting ClearAllLists
Note: This command clears all elements from the
lists. The list names are still in memory, but the lists
are empty.
Hint: In the CATALOG, you can go to the first item
starting with a particular letter:
TI-83 Plus: Press C (). Notice that you are
already in ALPHA mode since the Ø displays in the
upper right corner.
TI-73: Press - t, highlight C, and then press
b.
3. Setup the list editor with
Hint: You also can select SetUpEditor on the
TI-83 Plus by pressing ... 5.
4. Display the list editor.
Note: Lists L through L
1
there is a blank list following L
Topics in Algebra 1
and
ClearAllLists SetUpEditor
.
SetUpEditor
appear and are clear, and
6
.
6
© 2001 Texas Instruments
to reset the list editor.
Press
TI-83 Plus:
...
1:Edit
TI-73:
3
- l :
- |
# until
ClrAllLIsts
selected
b
b
- |
.
# until you highlight
SetUpEditor
b
b
TI-83 Plus:
...
1:Edit
TI-73:
3
³ TIp 6: Using Lists
Display
(TI-83 Plus shown)
is
³ TIp 6-2