Connecting The Water Supply Hose; In Case Of Cold-Hot Washer - Samsung WA127HA1 User Manual

CONNECTING THE WATER SUPPLY HOSE

1. Remove the adaptor
from the water
supply hose.
2. First,using a "+" type screw
driver, loosen the four screws
on the adaptor.
Next,take the adaptor and
turn part(b) following the arrow for
gap about 5mm between them.
3. Connect adaptor to the
water tap by tightening
the screws firmly.
Then, turn part (b)
following the arrow and
put (a) and (b)together.
4. Connect the water supply
hose to the adaptor. Pull down
the part (c) of the water supply
hose .When the part (c)is released,
the hose is automatically
connected to the adaptor
making a 'click' sound.
IN CASE OF COLD-HOT WATER WASHER
•
If you use only cold water inlet hose,
you must fit the cap to the hot water
inlet valve as following.
a
b
a
b
c
5. Connect the other end of the water
5-1.Connect the other end of the water
Screw the hose clockwise all the way in.
If the water tap is a screw type,assemble
a water supply hose that fits to the
tap as shown.
NOTICE After completing connection, if water leaks from the hose,
then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big,remove the spacing
ring before inserting the faucet into the adaptor.
cold
8
supply hose to the inlet water valve
at the back of the washer.
Screw the hose clockwise all the
way in.
supply hose to the inlet water valve
at the top of the washer.
hot
cap