Samsung 6 series User Manual page 28

Cable Network Setup-Auto Setup
If you connect the LAN cable and it supports DHCP, the Internet Protocol (IP) Settings are automatically configured. Please check
if the LAN cable is connected.
. Set Network Type to Cable.
. Select Network Setup.
. Set Internet Protocol Setup to Auto Setup.
The Internet Protocol is set automatically.
N
. Select Network Test to check the network connectivity.
Cable Network Setup-Manual Setup
To connect the TV to the LAN using a static IP address, you must set up the Internet Protocol (IP). Please check if the LAN cable is
connected.
. Set Network Type to Cable.
. Select Network Setup.
. Set Internet Protocol Setup to Manual Setup.
. Set up IP Address, Subnet Mask, Gateway and DNS Server.
Press the number buttons on the remote control when you set the Network manually.
N
. Select Network Test to check the network connectivity.
Wireless Network Setup (when Network Type is set to Wireless)

The menu is activated only if the 'Samsung Wireless LAN Adapter' is connected.
Internet Protocol Setup → Auto Setup / Manual Setup
●
● Network Test: You can test or confirm the network connection status after setting up the network.
When unable to connect to an AP
N
Your TV may fail to locate an AP that is configured as a private SSID type. In this case, please change the AP settings and
try again. If your Internet service provider has registered the MAC address of the device used to connect to the Internet
for the first time and authenticates the MAC address each time you connect to the Internet, your TV may not be able to
connect to the Internet as the MAC address differs from that of the device (PC). In this case, ask your Internet service
provider about the procedures to connect devices other than your PC (such as your TV) to the Internet. If you cannot
connect to the Internet even if you have followed the procedures of your Internet service provider, please contact the
Samsung Electronics Service Centre.
● Select a network
– Access Point: You can select the IP sharer to use when using a wireless network.
If a wireless Access Point is not in the Access Point list, press the Red button.
N
When the connection is made, you will be returned to the screen automatically.
N
If you have selected an Access Point with a security authentication: The Security Key input screen appears. Enter the
N
security key and press the Blue button on the remote control.
If security encryption type is WEP, 0~9, A~F will be available when you input security key.
N
English -