Driver And Flash Update; Driver Installation; Driver Update; Flash Update - RME Audio Hammerfall HDSP AES-32 User Manual

Hammerfall dsp system

Table of Contents

18. Driver and Flash Update

First fit the card (see 5. Hardware Installation), then switch on the computer and install the driv-

ers from the RME Driver CD. The driver file is located in the folder HDSP MADI AES32. Instal-

lation works automatically by a double-click on the file hdsp_madi_aes32.mpkg.

RME recommends to download the latest driver version from the RME website! If done, the

procedure is as follows:

Double-click onto madi_aes_253.gz to expand the archive file to madi_aes_253.tar and the

folder HDSP_MADI_253, which includes the driver file hdsp_madi_aes32.mpkg. Installation

works automatically by a double-click on this file.

During driver installation the programs Settings and Mixer (TotalMix) will also be installed. Both

programs start automatically as soon as a HDSP system is detected. They stay in the dock

when exited, and remove themselves automatically from the dock when the HDSP system is

removed.

Reboot the computer when installation is done.

In case of a driver update it's not necessary to remove the old driver first, it will be overwritten

during the installation.

The Flash Update Tool updates the HDSP AES-32 card to the latest firmware version. It re-

quires an already installed driver.

Start the program HDSP MADI AES-32 Flash. The Flash Update Tool displays the current revi-

sion of the HDSP AES-32 interface, and whether it needs an update or not. If so, then simply

press the 'Update' button. A progress bar will indicate when the flash process is finished. The

bar moves slowly first (program), then faster (verify).

If more than one interface card is installed, all cards can be flashed by changing to the next tab

and repeating the process.

After the update the PCI card needs to be reset. This is done by powering down and shutting off

the PC. A warm boot is not enough!

When the update fails (status: failure), the card's second BIOS will be used from the next cold

boot on (Secure BIOS Technology). Therefore the card stays fully functional. The flash process

should then be tried again on a different computer.

Table of Contents