Installation - Samsung SCH-211 Service Manual

3. Installation

3-1 Installing a Battery Pack
1. To attach the battery pack after charging, align
it with the phone about 1cm (1/2Ó) away from
its place so that the two arrows on the phone
are seen, the battery charge contacts pointing
downward.
2. Slide the battery pack upwards until it clicks
firmly into position. The phone is now ready
to be turned on.
3-2 For Desk Top Use
1. Choose a proper location to install the charger
for desk top use.
2. Plug the power cord of the charger into an
appropriate wall socket. When the power is
connected correctly, the lamps turn on briefly.
Samsung Electronics-Contents may change without notice.
SCH-211 MAIN
Standard Battery Pack
Figure 3-1 Charging the Phone and Battery
3. To remove the battery pack, release it by
pressing the button on the rear of the phone.
4. Slide the battery pack downward about 1cm
(1/2Ó) and lift it away from the phone.
3. To charge the battery pack, insert the battery
pack into the rear slot of the charger. The
lamp marked BAT on the front panel of the
charger lights up red.
4. If you do not wish to use the phone while
charging the battery, insert the phone with the
battery pack attached into the front slot of the
charger. The lamp marked PHONE on the
front panel of the charger lights up red.
Extended Battery Pack
Press this button to release
the battery pack
3-1