Table of Contents
Advertisement
Exploded View/Disassembly&Assembly Instructions
― LCD F-PCB KIT Assembly
1
1) At LCD backside, detach the release paper of the
both-sided tape
2) Like figure, attach the insulation tape at FPCB
backside. - Using cotton stick, rub down the
insulation tape to be tight.
3
1) Assemble the LCD hook.
※ Caution
First, assemble the left downside and then
assemble the right upside.
5
1) After soldering, attach the insulation tape along
the silk line.
- Using cotton stick, rub down the folded part not
to get loose.
※ caution : Be careful about "short"
of soldering part.
Recheck attaching part not to get loose.
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2
1) At attaching, align two FPCB HOLEs and two silk
points.
2) Attach and start the soldering.
※ Caution : At soldering, be careful about
getting loose and recheck alignment of silk
points and pads.
4
1) Align the right side EL FPCB and PBA Land and
start the soldering..
※ Caution Then, be careful about "short" of the
soldering part.
6
1) Wrap up and attach the left side insulation
tape to the PBA backside.(like figure)
※ caution : Recheck attaching part not to get
loose.
5-6
Advertisement
Table of Contents
