Table of Contents
Advertisement
Chapter 1 – Preparing to Use the Modem
Charging Cradle
Installation Overview
Before using the Modem Charging Cradle, its hardware and software
must be properly configured.
We have provided a step-by-step procedure to help you properly
configure your new Modem Charging Cradle. The procedure is divided
into two major tasks.
•
Preparing the cradle for first use, and
•
Configuring the Network Manager to communicate via the Modem
Charging Cradle.
Preparing the Modem Charging Cradle for First Use
Perform the following steps:
1. Connect the Modem Charging Cradle to Line Power using the
supplied power adapters listed on page 5
2. Connect the Modem Charging Cradle to the Phone Line
•
Using an RJ11 phone cord, plug one male end into a phone
wall outlet's RJ11 receptacle and the other into the cradle's
Line-In phone jack.
User's Guide for Modem Charging Cradle PS6PMCM
NOTE
A compliant telephone cable terminated with an
appropriate and correctly wired local telecom connector
compatible with the telephone network is required for
RJ11 connection (using middle line pair) to the modem.
CAUTION
Use only No. 26 AWG or larger telecommunication line
cord to reduce risk of fire.
WARNING
The Modem Charging Cradle is designed for
use on a standard analog phone (or Plain
Old Telephone Service (POTS)) line. Digital
lines used in PBX systems are not
compatible with the Modem Charging
Cradle and may damage the modem.
6
Advertisement
Table of Contents
