7
1) Insert Folder hinge into Front.
1) Be care of scratch and molding damage.
10
1) Folder Higher position assembling and after
Lower position assembling.
1) Be care of scratch and molding damage.
8
1) Sticking the foreign object projection Tape
by using a pinset.
2) Insert Keypad and Side Key.
1) Be care of scratch and molding damage.
11
1) Sticking a screw this four point at Rear.
1) Be care of scratch and molding damage.
9
1) Inter a PBA into the Front and assembling connector.
1) Be care of scratch and molding damage.