Installing The Stand; Disconnecting The Stand - Samsung UN46B6000 User Manual

Problem
The picture appears distorted in the
corner of the screen.
The 'Resets all settings to the default
values.' message appears.
This TFT LED panel uses a panel consisting of sub pixels (6 220 800) which require sophisticated technology to produce.
N
However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.

Installing the Stand

¦
Preset: Place the Guide Stand and Cover Neck onto the stand and fasten it using the
N
screws.
1. Attach your LED TV to the stand.
Two or more people should carry the TV.
N
Make sure to distinguish between the front and back of the stand when assembling
N
them.
To make sure the TV is installed on the stand at a proper level, do not apply excess
N
downward pressure to the upper left of right sides of the TV.
2. Fasten screws at position 1 and then fasten screws at position 2.
Stand the product up and fasten the screws. If you fasten the screws with the LED TV
N
placed down, it may lean to one side.
The stand is installed for models with the screen size of 55 inch and above.
N

Disconnecting the Stand

¦
1. Remove screws from the back of the TV.
2. Separate the stand from the TV.
Two or more people should carry the TV.
N
3. Cover the bottom hole with the cover.
Possible Solution
If Screen Fit When is selected with some external devices, the picture may
appear distorted in the corner of the screen. This symptom is caused by the
external devices, not TV.
This appears when you press and hold the EXIT button for a while. The
product settings are reset to the factory defaults.
English - 51
Back
Front
2
1