Advertisement
i:, Connect tilenine[)mplugremoved in step 8 tothe
connector board o nthe adapter harn_:ss.
i_. Dress t headapter harness along side ofthepresent
washer harness as shown¸
!!.
Using
the plastic
harness
ties, attach
1he adapter
harness to the washer harness.
Dress the hmness
in
such a manner
that it will not interlierc with any
moving parts or cause ally noise when die washer is
m operation.
i?. Connect the green connccto_
plug ll-om lhe adapte_
harness to the pump.
Re-install
the pump cover, if it
was removed in step !3.
I8. Connect
the green connector
phlg fiom the washer
harness to the connector on the adapter harness.
19. NOTE:
If the service kit's door lock is already pre-
wired to the adapter
harness,
go to step 20.
If the
service kit's door lock is not pre-wired
to the adapter
haHless, conned
the adapter
haraess
connections
to
the new door lock
2(} Matching
color [br color,
connect
the door switch
wires fiom tile washe_ harness
to the connectols
m
the adapter harness
21 Install the new door lock to the washer cabinet using
tile same screws removed in step 6
23. Connect
the washer to the electrical
power source
and test for proper operation.
Close the door, place
Ibe iilnel
to the final spin positioa,
and start tile
lilner. When the machine
starts its tRst ramp up to
tile
higber
spin
speed,
turn
the tirner
off; then
quickly pul! on the door handle to verify the door is
locked, lltlle door opens, recheck the connections
in
steps 9 through
12
24 Using the tube of adhesive,
glue the bellows to tile
l}ont panel at the 2. 3, & 4 o'clock
positions.
Wait
about two minutes,
tllen pull on the bellow to make
sure it is securely bonded to the flon! pane!.
2q Install the li-ont sel vice pntm!
Advertisement
