Table of Contents
Advertisement
4 Introduction
Quick start
Connector panel
The following steps outline the basic setup procedure for
connecting the projector to your computer. Detailed infor-
mation about connections for various computer sources is
described in Chapter 3, Detailed setup .
1 Aiming the projector lens at the projection screen, place the
projector on a solid, flat surface, at a right angle (perpendic-
ular) to the projection screen and parallel to the floor. Place
the projector the proper distance from your viewing screen.
2 Connect your computer or video source to the projector
(refer to the appropriate section for your computer, in Chap-
ter 3, Detailed setup , for detailed instructions).
SOURCE 1
SOURCE 2
L
R
L
R
VIDEO INPUTS
Input: 120/230V~
60/50Hz,5.0/2.5A
CAUTION !
For continued protection against the risk of fire,
replace only with the same type and rating of fuse.
Double pole / Neutral fusing
Type and Rating: T Slow-blow, 6.3A, 250V-
3 You can simultaneously view your desktop computer moni-
tor and project computer images with the projector by con-
necting your monitor to the REDRIVE port on the rear panel
OUTPUTS section. (Refer to the applicable setup procedure
in Chapter 3, Detailed setup to connect your monitor.)
SOURCE 3
SOURCE 4
OUTPUTS
STEREO
STEREO
STEREO
L
R
MAC / PC
PC / MAC
REDRIVE
RS 232
COMPUTER INPUTS
Advertisement
Table of Contents
