Quick Start - Polaroid Polaview 110 User Manual

Also included but • 2 AA alkaline batteries
not shown
• European power cord
• User's guide
• U.K. power cord
• Product registration card

Quick start

1 Unplug the monitor cable from the computer.
2 Plug one end of the supplied VGA cable into the RGB 1 IN
3 Connect your audio source to the AUDIO 1 IN port on the
4 You can project without using the PC monitor. To use the
5 Turn the projector on and press the STANDBY/ON key.
1 Unplug the monitor cable from the computer.
2 Plug one end of the supplied VGA video cable into the RGB
Place the Model 110 projector on a solid flat surface at a
right angle (perpendicular) to the projection screen, parallel
to the floor. Follow the appropriate section below for the
type of system that you have. These steps are described in
Chapter 2, Detailed setup.
The projector has two sets of computer video and
Note:
audio inputs. The following examples describe the use of
input 1.
Desktop PCs
port on the projector. Plug the other end into the computer
Monitor Out port.
p r o j e c t o r .
monitor, plug the monitor cable into the RGB OUT port on
the projector.
Desktop Macintosh computers
IN 1 port on the projector. Attach the VGA end of the Mac -
VGA cable adapter to the other end of the VGA video cable.
Introduction 3