Advertisement
● Safety Instructions
* It is very important to read and understand this manual completely before use. Keep this manual for future refer -
ence.
* When connecting/disconnecting cables and/or changing the phantom power setting or input level settings, turn the
input level control knobs to zero or power switch off.
* When the phantom DC48V power is not needed, make sure the phantom switch is in the off position.
* Before turning the phantom DC48V switch on, make sure your condenser microphone is designed to handle 48V DC
or the microphone may be damaged. Check the microphone's manual or with the manufacturer.
* Do not use other batteries than "AA" alkaline batteries. Do not mix fresh batteries with used ones.
* Remove the batteries if the mixer will not be used for a long period of time to prevent battery fluid leak.
● Front Control Panel
○
1
POWER INDICATOR: When the power switch (○
low for proper operation, the LED will turn red. When this happens, replace the batteries with fresh "AA" alkaline batter-
ies.
○
CHANNEL 1, 2 & 3 INPUT LEVEL CONTROLS: Each knob controls the input volume level of the microphone connected to
2
the corresponding input (○
○
CHANNEL 1, 2 & 3 OUTPUT SELECTORS: Let you select the output of each channel between LEFT, CENTER and RIGHT.
3
○
4
MASTER LEVEL CONTROL: This knob controls the overall volume level of all connected sources (microphone and/or line
-level devices).
○
CHANNEL 1, 2 & 3 LIMITER SWITCHS: Each input channel has a switchable limiter. After setting the input volume level,
5
turn this switch on. The limiter circuit will be activated and reduce the possibility of overload distortion from very loud
sounds without affecting normal sound volume. If you prefer the overall sound quality of the mixer without the limiter
circuit engaged, leave this switch off.
○
INPUT PEAK LEVEL INDICATOR: When the mixer detects signal overload and distortion, this LED will light in red. Lower
6
the input level by turning the corresponding input level control (○
○
7
CHANNEL LEFT & RIGHT OUTPUT LEVEL INDICATORS: These indicators will show the output volume level of the CH L
and CH R outputs (○
&○
13
14
knobs (○
) or the master level control knob (○
2
○
BATTERY COMPARTMENT: Open the lid by lifting it while pushing the tab.
8
12
). Zero is the lowest (quietest) setting while 10 is the highest (loudest).
9
). When the indicators show red, reduce the volume level by turning the input level control
).
4
)Is on, the LED will light in green. When the battery level becomes too
) counterclockwise.
2
2
Advertisement
