Page 1
FMX-DSLR 2-Channel Portable Audio Mixer Thank you for purchasing an Azden product. Please read this manual thoroughly before using this product.
The FMX-DSLR is equipped with the AGC On/Off switch that will allow you to control the wild swings of the Auto Gain Control (AGC) that plague most cameras. With the switch in off position, it will reduce noise during quiet moments of recording.
Page 3
8) Set the OUTPUT switch (○ ) to MONO when using one microphone. Set the unused channel level control (○ ) fully clock- wise to disable it to prevent noise. When using two microphones, you should normally set the switch to ST for stereo to keep each channel separated.
FRONT PANEL GAIN LOW/HI Switches OUTPUT Mode Selector MIC 1/LINE/MIC 2 Monitor Selector Selectors POWER indicator POWER Switch Output Peak LED Input Level MONITOR Level Controls Control LEFT-SIDE PANEL AUX (R) Input MIC 2 Input Camera Mounting Screw Jack Jack RTN Input Jacks PHONES Jack Ch-R XLR Input...
Page 5
○ POWER Switch ○ POWER Indicator LED: Green indicates power on and good battery condition. Red indicates low battery voltage. ○ Ch-L, Ch-R Input Volume Level Controls ○ Output Peak Indicator LED: When the output volume level is too high and the sound is distorted, the LED will light in RED. Reduce the volume level by turning the Input Volume Level Controls ○...
Page 6
Using the AGC ON/OFF Feature The Auto Gain Control (AGC) in the camera will vary the amount of gain depending upon the input signal level. During quiet moments, the AGC will increase the gain, which will also increase the amount of hiss from the camera preamplifiers. The AGC ON/OFF feature, when it is set to the OFF position, will trick the camera’s AGC in order to disable the wild swings of the AGC.
Specifications Inputs MIC 1/LINE: Two balanced 3-pin XLR connectors MIC 2: 3.5mm stereo jack AUX: 3.5mm monaural jack RTN: Two RCA inputs for playback monitoring Mode Setting Maximum Input Level Maximum Gain Input Impedance LINE/AUX +22dBu -22dB 19kΩ/10kΩ LINE/AUX +6dBu -6dB 19kΩ/10kΩ...
(at Azden’s sole discretion), within two years from the date of purchase. The cost to ship a failed product to and from Azden or to its dealer shall not be covered by this warranty. A dated receipt acts to establish the date of purchase and is all that is required for warranty service.