Table of Contents
Advertisement
8) Set the OUTPUT switch (○
wise to disable it to prevent noise. When using two microphones, you should normally set the switch to ST for stereo to
keep each channel separated.
9) Activate the 48V phantom power (○
not activate phantom power for dynamic microphones, condenser microphones that do not operate on phantom power,
wireless receivers, mixing boards or any unbalanced device as it may cause damage to both the mixer and connecting de-
vice.
10) Leave the AGC switch (○
"Using the AGC ON/OFF feature" in this manual for a detailed explanation on how this feature works.
11) Turn the POWER switch (○
12) Adjust the input level control (○
they turn red.
13) Plug your headphones into the PHONES jack (○
level. Be sure that you hear audio on both channels from the connected devices.
14) Do a test recording and playback to ensure that the captured audio is satisfactory.
15) To monitor the audio from the camera during playback, connect an AV cable with RCA plugs (not included but most likely
came with the camera) to the corresponding RTN (Return) input jack (○
put of the camera. Set the MONITOR selector (○
output.
) to MONO when using one microphone. Set the unused channel level control (○
7
) for only those microphones that require phantom power to operate. WARNING: Do
19
) in ON position for now. Before turning the switch to OFF position to disable AGC, please read
18
) on. The power LED (○
1
) for each channel so that the output peak LED's (○
3
) on the mixer and adjust the MONITOR level control (○
16
8
) should light green.
2
) on the mixer. Attach the other end to the AV out-
14
) to RTN and you will hear the sounds from the camera from the PHONES
3
) fully clock-
3
) stay green. Decrease the levels if
4
) to a comfortable
9
Advertisement
Table of Contents
