Helpful Hints; Programming A Recording With 'Turbo Timer - Philips VR740/02 User Manual

6.Enter the Start time (START) End time (STOP),
6.
Programme number (PROG.), VPS/PDC infor-
mation and the Date with
Programme numbers of the ' AV1 ' and ' AV2
' scart socket
You can also programme recordings from exter-
nal sources via scart socket AV1(TV)or AV2
(DECODER).
7.When all inputs are correct, press
7.
. The programming information
STATUS/EXIT
is stored in a TIMER block.
8.Insert a cassette with an intact security tab
8.
(unprotected).
9.Switch off with
9.
STANDBY/ON y y
The programmed recording will only function
when the video recorder is switched off with
STANDBY/ON y y .

Helpful Hints

Error message: ' ' will flash in the video
recorder display
•
No cassette was inserted. Insert a cassette and switch
off the video recorder using
•
A cassette was inserted with the security tab removed.
Undo the erase protection (chapter 'Manual
Recording', section 'Preventing accidental erasing') or
insert a different cassette.
Cassette is ejected during recording
•
The end of the tape was reached during recording.
The video recorder does not react
•
While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press
STOP / EJECT .
•
The end of the tape was reached during recording.
Error message: 'FULL'
•
If this error message appears after you select 'ONCE',
'DAILY', or 'WEEKLY' on TIMER menu and press
, then all TIMER blocks are already pro-
FWD 1- B
grammed. No more recordings can be programmed. If
you want to clear or check a programmed recording
select the programme number on
(TIMER block),
TIMER LIST menu and press
.
0..9
.
STANDBY/ON y y
.
CLEAR
20
Programming a recording with
'TURBO TIMER'
With Turbo Timer, programming a recording that
takes place within the next 24 hours is quick and
easy. You don't even need to switch your TV set
'on' as the necessary information will appear in
the VCR display. (the figures below are only
shown as examples)
1.
1.
Press
TURBO TIMER
' STA ' will briefly appear in
the video recorder display.
After 2 seconds, start time
will appear (default setting
is current time). Set the
time you want to start
recording using
PLAY B-K
STOP C-L
2.
2. Press
TURBO TIMER
' End ' will briefly appear in
the video recorder display.
After 2 seconds, the end
time will appear (default
setting is same as the start
time). Set the time you
want to finish recording
using
PLAY B-K
STOP C-L
3.
3.
Press
TURBO TIMER
' Pro ' will briefly appear in
the video recorder display.
After 2 seconds, default
program number will
appear in the display. Set
the desired program num-
ber using
PLAY B-K
.
STOP C-L
4.
4.
Press
TURBO TIMER
The program number you have just set will be
displayed.
Programming is now complete.
5.
5. Insert a cassette with an intact security tab
(unprotected).
6.
6. Switch off with
STANDBY/ON y y
The programmed recording will only function
when the video recorder is switched off with
STANDBY/ON y y .
PWR.
PWR.
PWR.
PWR.
.
PWR.
PWR.
.
PWR.
.
PWR.
PWR.
.
.
EN