Table of Contents
Advertisement
J
In some reception locations it is possible that a TV channel will be sent on the same or similar
frequency as the video recorder.
Result: As soon as the video recorder is switched on, the reception quality for this or several
other TV channels will decreased.
The following steps will show you how to change the pre-set 'transmission' (modulator)
frequency on the video recorder.
This electronic component in the video recorder allows the device to transmit
audio and video signals via the aerial cable. These signals can be received on a
TV set just like TV channels.
This frequency or channel indicates the frequency or channel on which the
audio or video signal is transmitted.
1
Switch on the TV set. Select the programme number used for video
recorder playback (see TV operating instructions).
2
Press STOP/EJECT ? to eject any cassette that might be in the
device.
3
Hold the STOP h button on the remote control.
press the STOP/EJECT ? button on the video
recorder until the pre-set modulator frequency e.g. 'M591' (591MHz
or UHF channel 36) appears in the display.
The video recorder will now transmit a test image on UHF channel
36/Frequency 591MHz.
4
Select line '
the new modulator frequency with the number buttons 0..9 .
5
Tune in the TV set to the new modulator frequency (channel 21 - 69)
shown in the video recorder display.
a
b The wrong sound system could have been selected.
In line '
disruptions using
' ' (TV system SECAM-D,K).
6
Confirm with OK .
'
' will appear briefly on the screen.
Optimising the modulator is now complete.
' using P ;q or P =r . Enter
', select the TV system with the least sound
SqP
QSr
or
. ' ' (TV system PAL-B,G) or
Suppressing interference
Hide quick links:
Advertisement
Table of Contents
