Other Precautions; First Steps; Installation - Frigidaire FRT105GW0 Use And Care Manual

OTHER PRECAUTIONS

• Never unplug the refrigerator by pulling on the cord.
Always grip the plug firmly, and pull straight out from
the receptacle.
• To avoid electrical shock, unplug the refrigerator before
cleaning and before replacing a light bulb.
NOTE: Turning the temperature control to OFF turns off the
compressor, but does not disconnect the power to the light
bulb or other electrical components.
• Do not operate refrigerator in the presence of explosive
fumes.
electric shock. Do not use an extension
cord or an adapter plug. Do not remove
any prong from the power cord.

FIRST STEPS

This Owner's Guide provides specific operating instructions
for your model. Use the refrigerator only as instructed in this
Owner's Guide. Before starting the refrigerator, follow
these important first steps.

INSTALLATION

• Choose a place that is near a grounded electrical outlet.
Do Not use an extension cord or an adapter plug.
• For the most efficient operation, the refrigerator should
be located where surrounding temperatures will not drop
below 10° F (-12° C) or exceed 110° F (43° C). The
Freeze Control Feature is designed to automatically
maintain the selected interior refrigerator temperature
within these boundaries.
• Allow space around the unit for good air circulation.
Leave a 4 inch (101.6 mm) space on the back and 3
inches (76.2 mm) on the sides and back of the
refrigerator for adequate circulation.
NOTE: The exterior walls of the refrigerator may become
quite warm as the compressor works to transfer heat from
the inside. Temperatures as much as 30° F warmer than
room temperature can be expected. For this reason it is
particularly important in hotter climates to allow enough
space for air circulation around your refrigerator.
Avoid fire hazard or
LEVELING
The refrigerator must have all bottom corners resting firmly
on solid floor. The floor must be strong enough to support a
fully loaded refrigerator. NOTE: It is Very Important for
your refrigerator to be level in order to function properly. If
the refrigerator is not leveled during installation, the door
may be misaligned and not close or seal properly, causing
cooling, frost, or moisture problems.
To Level Your Refrigerator:
After discarding crating screws and wood base, use a
carpenter's level to level the refrigerator from front-to-back.
Adjust the plastic leveling feet in front, ½ bubble higher, so
that the door closes easily when left halfway open.
CLEANING
• Wash any removable parts of the refrigerator interior, and
exterior with mild detergent and warm water. Wipe dry.
Do not use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when removing
adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild deter-
gent, or touch the residue with the sticky side of tape
already removed. Do not remove the serial plate.
3