Connecting The Ti-Graph Link Cable; Installing The Ti-Graph Link Software; Starting And Exiting; Ti-Graph Link - Texas Instruments TI-GRAPH LINK 2 Manual Book

Connecting the

TI-GRAPH LINK

Cable
Installing the
TI-GRAPH LINK
Software
Note: If you
download
TI-GRAPH LINK
from the TI web site
(page 3), see the
web for installation
instructions.
Starting and
Exiting
TI-GRAPH LINK
The TI-GRAPH LINK hardware connects to the Macintosh
via the USB port, modem port, or printer port of the
computer, and to the input/output port of the calculator.
1. Connect the TI-GRAPH LINK cable to your Macintosh.
If USB cable, connect one end of the cable to the
Macintosh USB port.
If gray cable, connect one end of the 8-pin to 25-pin
adapter cable to the Macintosh modem or printer
port on the rear of the unit. Connect the gray cable
to the 25-pin end of the 8-pin to 25-pin adapter cable.
2. Connect the other end of the TI-GRAPH LINK cable to
the calculator.
Important: The TI-GRAPH LINK cable must be
connected and the calculator turned on before getting
screens, and sending and receiving files. Push in all
connectors firmly.
If the software is on:
3½-inch diskette
You may want to copy
the diskette and use
the copy.
CD-ROM
All necessary files are installed on your hard drive,
including custom fonts used by the application.
On the Macintosh, open the
double-click the icon for the application. The
menu bar is displayed.
LINK
To close
TI-GRAPH LINK
Open the File
– or –
Press + on the Macintosh keyboard.
" Q
Then:
1. Insert the diskette into the
Macintosh.
2. Open the diskette and double-
click the
If your Macintosh is set for
Autostart, the installation
program starts when you insert
the CD.
Otherwise, open the CD and open
the folder for
Select the appropriate calculator
and language, and then
click the
TI-GRAPH LINK
:
menu, and then click
TI-GRAPH LINK 2 for Macintosh
Installer icon.
TI-GRAPH LINK.
double-
Installer icon.
folder and
TI-GRAPH
Quit .
5