Flush Mounting - Standard Horizon MST70 Owner's Manual

4. Screw or bolt the bracket into position. The mounting method will depend
on the material to which the bracket is being attached.
5. Slide the MST70 back into the bracket slots and adjust to the required
position before tightening the gimbal knobs.
6. Connect the antenna lead and electrical wiring as described later.

Flush Mounting

The MST70 can be neatly flush mounted into a panel or bulkhead so that just
the controls and the protective cover are visible. There are two flush mounting
options available. The best option for you will depend on your particular
situation.
• If the space behind the bulkhead or panel you have selected has a suitable
support shelf and the area is fully accessible, you can use the supplied
escutcheon panel as described later.
• If the space behind the bulkhead or panel is largely inaccessible or there is
no additional support shelf, we recommend you use the optional CMB60
flush mounting kit (available as an accessory). This kit is more robust, is fully
self supporting and allows the MST70 to be installed from the front.
Using the optional
Flush Mounting Kit
Installation using the supplied Escutcheon Panel.
1. Select a suitable location on a panel or bulkhead. Examine behind the
bulkhead to determine the best method of support for the unit.
2. Place the escutcheon on the panel or bulkhead in the required position and
mark around the outside edge of the escutcheon slot wall.
MST70
7.87"
200 mm
IMPORTANT DRAW
AROUND THIS EDGE
Owner's Manual
Escutcheon
Page 5