Programming recordings manually
1
Switch on the TV set. Press the
2
With the
P q
or
P r
Press the
TIMER k
button.
3
With the
, the
TIMER k
lect between the entries 'DATE' (date), 'PROG' (pro-
gramme number), 'START' (start time) and 'END' (stop
time).
With the
P q
or
P r
you can enter or adjust data.
You can switch 'VPS/PDC' (V/P) on and off at step 'START'
with the
button.
SELECT
You can select between 'D' (daily intervals) or 'W' (weekly
intervals) at step 'DATE' with the
4
Finally, press the
button. Programming is now com-
OK
plete.
5
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
ton.
Note:
* Clear a TIMER block: At step
that you want to clear, using the
Press the
button.
CLEAR (CL)
If e.g.: '20:00' flashes in the display, the clock must be set.
10
button twice.
TIMER k
button, select a free TIMER block.
or the
button you can se-
C
D
button or the digit buttons
button.
SELECT
STANDBY m
1
select the TIMER block
or
button.
P q
P r
Important programming notes
•
When recordings have been programmed,
the display.
•
The programmed recording will always be made at the
recording speed (SP/LP) that at the time has been
selected on the video recorder.
•
You cannot operate the video recorder manually while a
programmed recording is being made. If you want to
interrupt the programmed recording, press the
button.
STANDBY m
•
If the video recorder is switched on a few minutes before
a programmed recording is due to take place,
,
0-9
'TIMER RECORD' will flash on the TV screen.
•
If the end of the cassette is reached during a programmed
recording, the video recorder automatically ejects the
cassette.
•
If you forget to load a cassette, after programming the
recording, 'NO CASSETTE' will appear on the TV screen
for a few seconds.
•
If you insert a cassette with erase protection, after
programming the recording, 'PROTECTED CASSETTE' will
appear on the TV screen for a few seconds.
The cassette will then be ejected.
but-
•
When, after pressing the
appears on the TV screen, all TIMER blocks have been
programmed. Then, with the
the TIMER block you want to adjust or clear.
•
If 'CODE ERROR' appears on the TV screen, the
VIDEOPlus+ code was incorrect or the date was in-
correctly entered. Repeat the entry or end with the
STANDBY m
button.
With programming at daily intervals, the first recording
must take place within a week.
•
If 'DAILY ERROR' appears on the TV screen, the date was
incorrectly entered. Programming at daily intervals can
only be used for recordings to be made from Mondays to
Fridays inclusive.
•
Programme numbers 'E1' and 'E2' are provided for
programmed recordings from external sources (via the
or
EXT.1
EXT.2
k
button 'TIMER FULL'
TIMER k
P q
or
P r
scart socket).
appears in
button, select