Rear Panel - LinPlug Albino 3 Manual

Rear Panel

The "Rear Panel" of the Albino 3 is accessed by clicking on the Albino 3
logo at the bottom right of the Albino 3's front panel. Several master
controls have been located here to make the front panel less crowded, and
also so that they are not changed accidentally while the Albino 3 is in use.
The controls located here are Dial Mode, MasterTune, Bend Range and
Gen Range.
Master Tune is used to set the overall tuning of the Albino 3 if no
microtuning file is loaded . Tuning can be set from 415.3 Hz to 466.2 Hz.
The Gen Range control is used to set the range for random parameter
generation. It has a range of 0% to 100%. Using lower values will effect the
patch less than using higher values.
The Bend Up Range control is used to set the Albino 3's response to pitch
bend messages. Bend Range can be set from 0 to 24 semitones.
The Bend Down Range control is used to set the Albino 3's response to
pitch bend messages. Bend Down Range can be set from 0 to 24
semitones.
Rob Papen Albino 3.0 63