Glide; Single Trigger/Voices - LinPlug Albino 3 Manual

recommended that the Layer File controls are used. See the Layer section
of this manual for further information.
The Preset Browser section also contains a Layer display that shows the
number of Layers currently used by the Preset. When the display is blank
no Layers are being used. When the control displays "S" one Layer is being
used, and when the control displays "L" then 2 or more Layers are in use.

Glide

The Glide or "portamento" section allows you to set the Albino 3's
portamento parameters. "Glide" continuously changes the pitch from one
note to the next, connecting the notes and letting you smoothly "glide" from
one to the other.
The Glide section has three controls: the Glide control, the Range control,
and the Time/Rate control.
The Time/Rate control has two settings: Time and Rate. These settings
determine the manner in which the pitch of one note moves to that of the
next note. When set to "Time", it takes a constant amount of time to move
from one note to the next. In this case it will take the same amount of time
to reach the destination pitch regardless of whether the preceding notes
are a semitone apart or an octave apart. When set to "Rate", the amount of
time it takes to move from one note to the next depends upon how far apart
the two notes are. The further apart the notes, the longer it will take for the
pitch of the first note to reach that of the following note.
The Glide button has 4 values: Off, Held, On and Bend. The On and Off
functions turn "Glide" on and off. When "Glide" is on, the Time/Rate dial is
used to set the length of time it takes for the first note to reach that of the
second note. The "Held" setting works as follows. If notes overlap then
Glide is applied, however if they don't then the notes are played without
Glide. This makes it possible to apply Glide only to selected notes. "Bend"
allows you to apply a predetermined pitch bend to each note. The bend
range is set using the Range control. A bend range of -48 to +48 semitones
is available.

Single Trigger/Voices

The Single Trigger control is used to activate single trigger mode. When
this switch is activated envelopes are only triggered by non-legato (or
separated) notes. If you play in a legato (or overlapping) manner then
Rob Papen Albino 3.0 61