Alignments And Adjustments - Haier HGRA202QABS User Manual

ALIGNMENTS AND ADJUSTMENTS

Installation
It is the responsibility of the installer to make certain that the range is properly adjusted
at the time of installation. Situations caused by improper adjustments or improper
installation are not covered under the warranty. Any expenses incurred due to such
situations will not be paid by the manufacturer of the appliance.
Gas Range Conversion and Adjustment Guide
The range will either be set for use with Liquefied Petroleum (LP) or Natural Gas. The
factory setting is indicated on the serial plate. When set for Natural Gas operation, the
pressure regulator will regulate the pressure to 4 inches water column. When set for LP
Gas operation, the pressure regulator will regulate the gas to 10 inches water column
pressure.
On sealed burner models the main top must be removed to adjust regulator, burner
orifices and thermostat from NAT to LP (propane) or vice versa. See illustration.
Pressure Regulator
Burner Venturi
Front (2)
Push & Turn Valves
Ignitor Attachment
Screw
Attachment Screw
Burner Bowl
Burner Venturi
Burner Cap (4)
Attachment
Screws (4)
Main Top
BURNER HEAD ASSEMBLY
Main Top
Partial View
MAIN TOP /BURNER ASSEMBLY
13
Backguard
Burner Venturi
Rear (2)
Burner Head
Paper Clip
Ignitor Wire