Gigabyte G-MAX Micro ATX Series User Manual page 5

Hide thumbs Also See for G-MAX Micro ATX Series:

1. Insert the CPU on the CPU socket. Before installation, lift up the lever and align the

cut of the CPU with the marking on the socket.

2. Pull down the lever to lock the CPU on the socket after installation. When you are

installing the heat sink, please make sure to keep the heat sink tight against the

CPU to obtain the best cooling result.

3. Apply the thermal compound to one side of the template, and ensure the compound

is spread evenly across the template and repeat if necessary.

4. Connect fan power connector to the CPU FAN connector on the motherboard.



CPU(For Intel

Pentium

CPU Pin

1.Insert the CPU on the CPU socket. Before installation, lift up the lever and align the

cut of the CPU with the marking on the socket.

2.Pull down the lever to lock the CPU on the socket after installation. Put CPU cooler

on retention module and make sure to keep the heat sink tight against the CPU to

obtain the best cooling result. Lock the cooler on retention module.

3. Apply the thermal compound to one side of the template, and ensure the compound

is spread evenly across the template and repeat if necessary.

4. Connect fan power connector to the CPU FAN connector on the motherboard.

G-MAX

Click heat sink

lock on the CPU

socket



4 processors)

Lever

Click the heat sink

locker to the

motherboard

retention module.

P. E5

Micro ATX Series User's Manual

Install fan on top of CPU