Download Table of Contents Print this page

Before Setting Oven Controls - Frigidaire ES200/300 Use & Care Manual

Electric range controls, self-cleaning oven with ceramic cooktop
Hide thumbs Also See for ES200/300:
Table of Contents


Removing & Replacing Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Using proper cookware
Cookware should have flat bottoms that make good contact with the entire surface heating
element. Check for flatness by rotating a ruler across the bottom of the cookware (See
Fig.1). Be sure to follow the recommendations for using cookware as shown in Fig. 2.

Before Setting Oven Controls

Oven Vent Location
For models equipped with ceramic cooktops, the oven vent is located under the
left rear side of the control panel. When the oven is on, warm air is released
through the vent. This venting is necessary for proper air circulation in the oven
and good baking results. DO NOT BLOCK OVEN VENT.
Arranging Oven Racks
OPERATING THE OVEN). Always use oven mitts when using the oven.
Figure 2
Note: The size and type of cookware used will influence
the setting needed for best cooking results.
Deep fat frying - Use a thermometer and adjust the
surface control knob accordingly. If the fat is too cool, the
food will absorb the fat and be greasy. If the fat is too hot,
the food will brown so quickly that the center will be
undercooked. Do not attempt to deep fat fry too much food
at once as the food will neither brown nor cook properly.
Figure 1

Hide quick links:


Table of Contents

Table of Contents