SERVICE DATA SHEET
Gas & Electric Wall Ovens with Electronic Oven Control (ES 300)
This service data sheet is intended for use by persons having electrical and mechanical training and a level of
knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer
cannot be responsible, nor assume any liability, for injury or damage of any kind arising from the use of
this data sheet.
SAFE SERVICING PRACTICES
To avoid the possibility of personal injury and/or property damage, it is important that safe servicing practices be
observed. The following are some limited examples of safe practices.
1. Do not attempt a product repair if you have any doubts as to your ability to complete it in a safe and satisfactory
2. Before servicing or moving an appliance, remove power cord from electric outlet, trip circuit
breaker to Off, or remove fuse.
3. Never interfere with the proper installation of any safety device.
4. USE ONLY REPLACEMENT PARTS CATALOGED FOR THIS APPLIANCE. SUBSTITUTIONS MAY DEFEAT COMPLIANCE
WITH SAFETY STANDARDS SET FOR HOME APPLIANCES.
5. GROUNDING: The standard color coding for safety ground wires is GREEN OR GREEN WITH YELLOW STRIPES.
Ground leads are not to be used as current carrying conductors. IT IS EXTREMELY IMPORTANT THAT THE SERVICE
TECHNICIAN REESTABLISH ALL SAFETY GROUNDS PRIOR TO COMPLETION OF SERVICE. FAILURE TO DO SO
WILL CREATE A POTENTIAL HAZARD.
6. Prior to returning the product to service, ensure that:
All electric and gas connections are correct and secure.
All gas connections are tested for leaks. DO NOT TEST FOR GAS LEAKS WITH A FLAME.
All electrical leads are properly dressed and secured away from sharp edges, high-temperature components,
and moving parts.
All uninsulated electrical terminals, connectors, heaters, etc. are adequately spaced away from all metal
parts and panels.
All safety grounds (both internal and external) are correctly and securely reassembled.
All panels are properly and securely reassembled.
ES300 ELECTRONIC OVEN CONTROL
The ES300 electronic oven control is almost identical to the current control with a few exceptions.
The ES300's are not field repairable. Only temperature settings can be changed. See Electronic Oven Control
Guide (section recalibrating your oven temperature)
Depending on model, the size and shape of touch pads may vary (for example elliptical instead of round).
During a normal bake mode, the control preheats the oven with the bake element. When the desired temperature
is reached, the control adds top heat by cycling the broil element on for 6 to 9 seconds per minute . The bake element
is on for the remaining time of the minute. Both elements use full power when they are on but they are never on at
the same time.
318047410 (0205) Rev. C