Appendix C - Ps 2 Interface - Omnitron Systems Technology MAH 200 Quick Start Manual

APPENDIX C – PS 2 INTERFACE
Installation Guide
1. Power off the host computer.
2. Attach the end of the PS2 cable with the single connector
3. If external keyboard exists, unattach your keyboard from the host and connect the appropriate
connector to the PS2 cable
4. Connect the other connector to host computer into keyboard port
by the PS2 port and does not require a power supply.
5. Set the MAH 200 to PS2 mode by scanning the code below, then scan the Save Settings code:
PS2 Mode
6. Your MAH 200 unit is now ready. Open the appropriate application
application that accepts Keystroke data – e.g. Notepad)
Upgrade Note: The PS2 model does not work with a USB cable. If you are upgrading the
firmware you must use an RS-232 cable.
WARNING: Code does not recommend using Batch or Bluetooth Radio modes with the PS2
interface because you need to disconnect the MAH 200 and the keyboard and this may result in
the host computer freezing and requiring you to reboot.
.
Save Settings
QUICKSTART GUIDE
CODE READER MAH 200
to the MAH 200.
. The MAH 200 is powered
(any Windows based
and begin scanning data.
C -3