Using The Remote Control - Optimus STAV-3580 Owner's Manual

Using the Remote Control

22
The remote control works up to a distance of about 23 feet, and within a 30-
degree angle on either side of the receiver. Point the control at the receiver's
front panel and press the desired button(s).
Many buttons on the remote control work the same as buttons on the receiver's
front panel. Use these buttons exactly as you would use the corresponding but-
tons on the receiver.
AUDIO VCR Switch
The remote control can also control other compatible audio/video components
when you connect them to the receiver's
to control audio components such as CD players or cassette decks. Set
AUDIO
the switch to
When you set the switch to
marked in gold next to the button. For example, the button marked
MODE and TEST TONE
switch to
AUDIO
Receiver/Amplifier Section
FUNCTION
– MASTER VOLUME +
CENTER MODE
– CENTER +
Receive
Amplifie
Section
– REAR +
TEST TONE
DELAY TIME
SURR MODE
SLEEP
RECEIVER POWER
RETURN
3CH LOGIC
TAPE 2 MONITOR
VCR to control video components such as a VCR.
, dual-function buttons control the function
VCR
operates as the center mode adjust when you set the
and as the test tone function when you set the switch to
Selects a program source (VCR/Tape 1, LD, CD, tuner, or
phono). Repeatedly press FUNCTION until the display shows
your desired program source. See Page 14.
Adjusts the system's volume. See Page 14.
Selects among the three center mode settings with AUDIO
VCR set to AUDIO. See Page 21.
Controls the relative volume of the center speaker with
AUDIO VCR set to AUDIO. See Page 21.
Controls the relative volume of the rear speakers with
AUDIO VCR set to VCR. See Page 21.
Sounds test tones from each speaker with AUDIO VCR set to
VCR. See Page 21.
Sets the rear-channel delay for Dolby Pro-Logic Surround
and Simulated Surround programs with AUDIO VCR set to
VCR. See Page 21.
Selects between Dolby Pro-Logic Surround or Simulated Sur-
round sound. See Page 20.
Sets the receiver to turn off after 90, 60, or 30 minutes with
AUDIO VCR set to AUDIO. To start the timer, repeatedly
press SLEEP until the desired turn-off time (
appears. To cancel the timer, repeatedly press SLEEP until
the sleep time disappears from the display. See Page 17.
Turns the receiver on and off. See Page 14.
Returns the receiver to its default settings. See Page 25.
Selects Dolby 3CH Logic. See Page 20.
Switches the receiver to monitor the source connected to the
TAPE 2 MONITOR jacks. See Page 18.
jack. Set the switch to
CONTROL OUT
90
CENTER
.
VCR
, 60 , or 30 )