Using One Remote Control For More Than One Unit; Installing The Remote Control's Batteries - Optimus STAV-3580 Owner's Manual

Preparing Your Receiver
Using One Remote Control
for More than One Unit
Note: When you plug the cable into a
component's
CONTROL IN
component's remote sensor does not
function.
CONTROL
IN
OUT
CONTROL
Other Component
Receiver
with OSR Mark
Remote
Control
Installing the
Remote Control's Batteries
Cautions:
• Use only fresh batteries of the recom-
mended size and type.
• Always remove old or weak batteries.
Batteries can leak chemicals that can
damage electronic circuits.
Note: If the remote's range is reduced,
replace the batteries immediately.
12
If you also have an Optimus professional series CD player, VCR, or cassette
deck with the OSR mark, you can connect its
so you can control all of your equipment with a single remote control. You can
also use the other component's remote control by pointing it at the receiver's
front panel.
jack, that
1. Connect each component to the receiver as shown in "Connecting Pro-
gram Sources" on Page 8.
Note: You must connect the audio cables between the receiver and the
other audio accessory to use your receiver's remote control to control the
IN
accessory.
OUT
2. Connect the cable supplied with the CD player, VCR, or cassette deck
between the receiver's
CONTROL IN
3. When you want to control more than one other component using the
receiver's remote control, daisy-chain the
IN
To the CONTROL IN ja
of Another Componen
Having the OSR Mark
The remote control uses two AA batteries (not included). For the longest battery
life, we recommend RadioShack's alkaline batteries (Cat. No. 23-557).
1. Press and open the battery
compartment cover.
2. Place two fresh AA batteries in
the compartment as indicated by
the polarity symbols (+ and –)
marked in the compartment.
3. Replace the battery compartment
cover.
CONTROL OUT
jack.
connections as shown.
jack to the receiver
CONTROL IN
jack and the other component's
CONTROL OUT and CONTROL