Table of Contents
Advertisement
Overview
This document contains step-by-step disassembly instructions for the Packard Bell Compasseo. The
instructions are illustrated where necessary with images of the part that is being removed or
disassembled.
Packard Bell reserves the right to make changes to the product without notice.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
Turn off the power using the battery switch.
Disconnect the adapter.
Remove the SD or MMC card from the device.
Do not disassemble the system into parts that are smaller than those specified in the
instructions.
Label all removed connectors; note where the connector goes and in what position it was
installed.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are
returned to their proper positions. Check that no tools or any loose parts have been left inside the
chassis. Check that everything is properly installed and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
Small Phillips screwdriver
1
Advertisement
Table of Contents
