Sanyo VPC-E2100 Instruction Manual page 71

CAUTIONS CONCERNING THE DOCKING STATION AND AC ADAPTOR/
DANGER
Do not recharge a battery
pack other than the specified
battery pack
• Recharging a dry-cell battery or
other type of rechargeable battery
may cause excess heat, combustion,
or leakage, and cause a fire,
injuries, burns, or damage to nearby
objects.
Concerning the power cord
• The voltage rating for the power
cord supplied with this camera
conforms to the standards of the
country in which the camera was
sold.
Do not get the docking station
or AC adaptor/charger wet
• Make sure they do not get wet, as
doing so may cause a fire or electric
shock.
• Do not use them in a bathroom.
• If the docking station or AC
adaptor/charger gets wet,
immediately unplug it from the
power outlet and remove the battery
pack. Then contact the place of
purchase. If used while wet, it may
cause a fire, electric shock, or an
accident.
WARNING
Cautions when plugging in the
power cord
• Securely plug the power cord all the
way into the power outlet. If the
docking station or AC
adaptor/charger is used with the
power cord not fully plugged in, heat
may be generated and cause a fire.
• Do not use if the power cord is
damaged or cannot be correctly
plugged into the power outlet. Using
in this condition may cause a fire or
electric shock.
• Do not allow dust, etc., to build up
on the power cord or power outlet. A
build-up of dust may cause a short
circuit or generate heat and cause a
fire. Use a dry cloth to remove dust
or dirt build-up after unplugging the
cord from the power outlet.
• When unplugging the power cord,
be sure to hold the plug part and
slowly pull it out of the power outlet.
Pulling the cord portion may damage
the power cord and cause a fire or
electric shock.
CHARGER
70
Do not damage the power cord
• Do not place heavy objects on the
power cord. Do not place the power
cord near a heat source. Do not
excessively bend the power cord,
modify it, or secure it with staples.
Doing so may damage the power
cord and cause a fire or electric
shock.
• If the power cord is damaged, or if it
does not plug properly into the
docking station, AC adaptor/charger
or wall outlet, contact the place of
purchase.
Cautions concerning the
power cord
• Do not leave the power cord plugged
into an electrical outlet while the
other end is not plugged into the AC
adaptor/charger. The loose end can
cause electrocution if touched with
wet hands or if handled by children.
• Use only the supplied power cord. If
a different power cord is used, it may
be rated for a different current load,
and that may cause a fire.
• The supplied power cord is for
exclusive use with the AC
adaptor/charger supplied with your
camera. Do not use it with other
devices, as doing so may cause a fire
or electric shock.
• Do not use a bundled power cord, as
the heat generated may cause a fire.
Do not touch the power cord
plug with wet hands
• Doing so may cause an electric
shock.
CAUTION
Do not hold the hot part for a
long time
• The device(s) may become warm
during use. A low temperature burn
may result if you hold the hot part for
a long time.
Do not place on an unstable
surface
• If may fall, resulting in damage or
injury.
• If the device has fallen or has been
trampled on, and its body is
damaged, turn it off, remove the
battery, and take it to the dealer for
repair. Using the device after its body
has been damaged may cause a fire
or electric shock.