Troubleshooting - Sega Jambo!Safari Owner's Manual

15. TROUBLESHOOTING

Should trouble occur, first check connector connections.
PROBLEMS
With Main SW
ON, no activation
Operation is
unsatisfactory
Irregular sound
emitted from
inside Rear Cabinet
The color of the
image on PROJ.
screen is incorrect.
The image on PROJ.
screen has color
deviation.
No sound is emitted.
NETWORK check
will not finish.
Communication play
is not possible.
No sound from
Cockpit.
The Fluorescent
lamp does not
light up.
Shift operation is not
satisfactory in
gameplay.
CAUSE
Power is not supplied.
Power supply/voltage is not correct.
AC main fuse causes the
power to be cut off due to momentary
overload.
Volume Setting Failure
Poor mesh of V.R. gear.
Spring failure due to secular change
of Accelerator and Brake Mecha.
Greasing to gear mesh portion is not
satisfactory, or extraneous matter
mixed in.
Connector connections are defective.
Affected by the magnetic field of
installation location.
Sound Volume adjustment is not
appropriate.
Sound BD and speaker are
malfunctioning.
NOT AVAILABLE
NOT AVAILABLE
In correct Cabinet Type Setting.
The Fluorescent tube is burnt out.
Shift SW malfunctioning.
COUNTERMEASURES
Plug in correctly
Make sure that power supply/voltage is
correct.
Check fuse. Remove the cause of
overload and replace fuse
Perform Volume setting
Adjust or replace V.R.
Adjust Gear mesh..
Replace the Spring.
Apply greasing or eliminate extraneous
matter.
Check the connection for the RGB and
SYNC connectors of the PROJ. TERM.
BD and VPM BUFFER BD.
Make CONVERGENCE adjustment.
(Refer to Section 12.)
Adjust sound volume. (see Section 7).
Perform sound test to find and replace
defective parts.(Refer to Section 7).
NOT AVAILABLE
NOT AVAILABLE
Correct Cabinet Type Setting.
Replace the Fluorescent tube
(Refer to Section 11).
Replace SW
48