Table of Contents
Advertisement
Description
1. Front of Sensor Box
Relay Out: Plug the relay cable into this port. It connects directly to the
device you want to control.
Relay On:
This green light is on as long as the relay is closed/switch
closure occurs.
Valid:
The valid light flashes three times when the unit is turned
on, when the dip switches are changed or the mode is set.
To Sensor: The end of the sensor plugs into this port.
Mode/Status: Flashes when switch closure occurs.
Sens Power: The red light blinks continuously as long as the sensor box has
power.
Off/On:
Slide to off position when not in use.
Charge:
The light stays on while the unit is being charged.
4
Advertisement
Table of Contents
