VMware vSphere ESXi 4.0 Management Manual page 98

vSphere Resource Management Guide
Procedure
To activate replay mode, enter the following at the command-line prompt.
u
esxtop -R <vm-support_dir_path>
Replay Mode Command-Line Options
You can use replay mode with command-line options.
Table A-18 lists the command-line options available for
Table A-18. Command-Line Options in Replay Mode
Option
R
a
b
c<filename>
d
n
98
Description
Path to the vm-support collected snapshot's directory.
Show all statistics. This option overrides configuration file setups and shows all statistics. The
configuration file can be the default ~/.esxtop4rc configuration file or a user-defined
configuration file.
Runs esxtop in Batch mode.
Load a user-defined configuration file. If the -c option is not used, the default configuration
filename is ~/.esxtop4rc. Create your own configuration file and specify a different filename
using the W single-key interactive command.
Specifies the delay between panel updates. The default is five seconds. The minimum is two
seconds. If a delay of less than two seconds is specified, the delay is set to two seconds.
Number of iterations esxtop updates the display this number of times and then exits.
replay mode.
esxtop
VMware, Inc.