4:14 pm Page 2 Vax Careline: 0870 6061248 www.vax.co.uk Please read carefully before using the carpet washer. Always fully Upright Carpet Washer extend the mains cable before use. Please retain these instructions Vax Model Number: V-021 for future reference. Instruction Manual...
Page 2
V-021 User Guide.qxd 5/6/06 4:14 pm Page 3 Parts Overview 1. Diagram Fig.1/1 Fig.1/2 Handle Dirty Water Tank Clean Water Tank Release Solution Release Trigger Button Power Cord Tidy spring Clean Water Tank Power Cord Holder Dirty Water Tank Latch...
NOTE: Carpets should vacuumed thoroughly before washing. NOTE: If the supply cord is damaged, it must be replaced by the manufacturer, a Vax service agent or similarly qualified persons in order to avoid hazard. Fig.3/4 - 3 Screws...
Page 4
V-021 User Guide.qxd 5/6/06 4:14 pm Page 5 Preparing the Machine/Assembly Insert and tighten screws as indicated. Insert Screw Insert Screw Insert Screw Fig.3/5 - Clean Water Tank Assembly Fig.3/8 Line up mid-section with base unit and slot into place (as shown).
HELPFUL HINTS FOR CLEANING CARPET: Only use Vax AAA Carpet Cleaner with this carpet washer. Do not oversaturate carpet with cleaning solution while using the carpet washer.
Page 6
V-021 User Guide.qxd 5/6/06 4:14 pm Page 7 Troubleshooting Fill remainder of clean water tank with warm (max 40°C) tap water. Replace cap. Fig.6/1 IMPORTANT: For best cleaning results use a Fig.5/3 steady, moderate, forward and backward motion. Always work from back to front across the room to Place bottom of clean water tank into carpet avoid stepping on wet carpet and lowering the pile.
Monday-Friday. 9.00am to 5.00pm. An answerphone will be available out of these hours. Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your carpet cleaner before calling.
Page 8
4:14 pm Page 1 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility declare that the product V-021 Rapide Spring is manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste.
Need help?
Do you have a question about the Rapide Spring V-021 and is the answer not in the manual?
Questions and answers