Jump Starting - Vauxhall Ampera Owner's Manual

168 Vehicle care
The tyre repair kit has an accessory
adapter located in a compartment on
the bottom of its housing that may be
used to inflate air mattresses, balls,
etc.
Removal and installation of the
sealant canister
To remove the sealant canister:
1. Unwrap the sealant hose.
2. Press the canister release button.
3. Pull up and remove the canister.
4. Replace with a new canister
which is available from
a workshop.
5. Push the new canister into place.

Jump starting

Jump starting is connecting jumper
cables between the two vehicles to
enable vehicle starting. If the vehicle
or another vehicle has a run‐down
12 volt battery, it can be jump started
using good condition jumper cables.
There are different procedures
depending on if the vehicle has a run‐
down battery or another vehicle has
a run‐down battery. Read the
appropriate procedures that follow.
9 Danger
The high voltage battery cannot be
jump started either with another
vehicle or battery charger.
Personal injury, death, or damage
to the vehicle could result.