Tail Lights; Reversing Light; Side Turn Signal Lights - Vauxhall Ampera Owner's Manual

144 Vehicle care
Passenger side headlights
To replace the high/low‐beam
headlight:
1. Remove the cover from the back
of the headlight assembly by
turning it counterclockwise.
2. Remove the bulb from the
headlight assembly by turning it
counterclockwise.
3. Disconnect the bulb from the
wiring harness connector.
4. Install the new bulb in the
headlight assembly by turning it
clockwise.
5. Reconnect the wiring harness
connector.
6. Install the cover on the back of the
headlight assembly by turning it
clockwise.

Tail lights

Have the lights replaced by
a workshop.

Side turn signal lights

Have bulbs replaced by a workshop.

Reversing light

A = Reversing light
B = Rear fog light
1. Remove the three inboard screws
from the aero panel located under
the rear fascia.
2. Push up on the aero panel to
locate the reversing light bulb
socket (A).
3. Turn the bulb socket (A)
counterclockwise to remove it
from the bulb assembly.
4. Pull the bulb from the bulb socket.
5. Push a new bulb straight into the
bulb socket.
6. Reinstall the bulb socket by lining
up the tabs and turn it clockwise
to lock it into place.
7. Replace the three inboard screws
into the aero panel.