Jack And Vehicle Tools; Wheel Changing - Vauxhall MOVANO Owner's Manual

Jack and vehicle tools

The jack, adapter, ratchet, extension bar
and towing eyes are contained in a unit,
stowed under the driver's seat.
Open the unit by pulling off the two end
pieces. For safety reasons always reinstall
the tools as shown on the end pieces.

Wheel changing

In order to reduce the chance of possible
injuries, make the following preparations
and note the procedure:
z Park on a level, firm and non-slippery
surface.
z Switch on hazard warning lights and
apply handbrake. Engage first gear or
reverse.
z Correctly set up warning triangle.
z No people or animals may be in the
vehicle when it is jacked-up.
z Before lifting the vehicle, turn front
wheels to straight-ahead position.
z Never change more than one wheel at a
time.
z Block wheel diagonally opposite the
wheel to be changed by placing wedge
blocks, any available blocks of wood or
rocks behind and in front of it.
z Use jack only when changing wheels.
z If the ground on which the vehicle is
standing is soft, a solid board (max. 1 cm
thick) should be placed under the jack.
Using a thicker board could lead to
damage of the jack and the vehicle.
z Never crawl under a jacked-up vehicle.
z Do not start or run the engine while the
vehicle is on the jack.
Self-help
Wheel changing procedure
1. Remove wheel trim and loosen the wheel
bolts with the ratchet, extension bar and
adapter. The ratchet should turn
anticlockwise to loosen the bolts - invert
the ratchet if necessary.
2. To raise vehicle, place locating peg of
the jack under the jacking hole located
nearest the wheel concerned.
121