Notes On The Documentation; Storage Of The Documents; Symbols Used; Validity Of The Manual - Vaillant ecoTEC exclusive 832 Installation And Maintenance Instructions Manual

1

Notes on the documentation

1 Notes on the documentation
The following information is intended to help you
throughout the entire documentation.
Further documents apply in combination with this instal-
lation and maintenance manual.
We accept no liability for any damage caused by fail-
ure to observe these instructions.
Other applicable documents
> During installation, you must observe all the installa-
tion instructions for the assemblies and components
in the system.
These installation instructions are enclosed with the var-
ious system components as well as additional compo-
nents.
> Also observe all the operating manuals included with
the system components.
1.1

Storage of the documents

> Hand these installation instructions and all other
applicable documents to the plant operator.
The operator must keep the instructions so that they are
available if needed.
1.2

Symbols used

The symbols used in the manual are explained below:
a
Symbol denoting danger
– Imminent danger to life
– Risk of severe personal injury
– Risk of minor personal injury
e Symbol denoting danger
– Risk of death from electric shock
b
Symbol denoting danger
– Risk of material damage
– Risk of damage to the environment
i Symbol denoting additional useful tips and
information
>
Symbol for a required action
4
1.3

Validity of the manual

This installation manual applies exclusively to units with
the following part numbers:
– 0010002668
– 0010002669
The part number of the unit can be obtained from the
identification plate.
1.4

CE label

CE labelling shows that the appliances comply with the
basic requirements of the following directives:
– Directive 2009/142/EEC of the Commission with
revisions
"Directive for Harmonisation of Legal Regulations of
the Member States for Gas Consumer UNits" (Gas
equipment directive)
– Directive 92/42/EEC of the Commission with revi-
sions "Directive Concerning the Efficiency of New Hot
Water Heating Boilers Fired by Liquid or Gaseous
Fuels" (Efficiency directive)
– Directive 2006/95/EEC of the Commission with revi-
sions "Directive Concerning Electrical Operating
Equipment for Use Within Specific Voltage Limits"
(Low voltage directive)
– Directive 2004/108/EEC of the Commission with
revisions "Directive Concerning Electromagnetic Com-
patibility"
The units comply with the prototype described in the EU
Prototype Test Approval:
PIN-No. CE-0085BR0308
The units comply with the following standards:
– EN 483
– EN 625
– EN 677
– EN 50165
– EN 55014
– EN 60335-1
– EN 60529
– EN 61000-3-2
– EN 61000-3-3
Installation and maintenance instructions ecoTEC exclusive 0020017768_07